Free Web Hosting Provider - Web Hosting - E-commerce - High Speed Internet - Free Web Page
Search the Web

vadermakerheaderGO.gif (11862 bytes)

sectionsheaderGO.gif (478 bytes)

vadermaker

vadermakercentralheaderGO.gif (983 bytes)

COD PIECE - $20 complete stars2.gif (222 bytes)

FULL COD PIECE INSTRUCTION WITH PICTURES - click here!

COD PIECE TEMPLATE 100% SCALE - click here!

This is the piece that you will feel the most satisfaction from completing correctly, it starts with drawing a template onto card, then transfering this onto 0.5mm wood, once done and cut out, slice the template into 4 sections (imagine that this will allow the board to wrap around you!), re-attach with small bracket hinges. Now cut the exact same shape from 1" thick foam, glue this to the front of the piece, now the hard part...
Take your 'leather look' material and cut out the template shape, BUT with 2" extra all-round, now you have to stretch fit the leather all the way round the piece, using a staple gun to attach, this has to be done very slowly and very accurately, check the piece every inch or so to make sure that the material is not pinching - you want to finish with a super smooth look and NO CREASING!! - Below Pictures...

cod1GO.gif (25223 bytes) cod2GO.gif (24735 bytes)

The downloadable instructions will give you a much better idea of how to create this piece, determination and a steady hand are the key, but look at the quality of the leather - Below Pictures...

cod3GO.gif (24865 bytes) cod4GO.gif (26986 bytes)

Attaching the cod piece is done by creating a belt loop harness, have a main belt going from side to side, to this attach another loop belt going under the groin area, this will stop the piece from moving away from you while wearing, we have used a standard luggage belt - Below Pictures...

vadcodclip1.gif (30464 bytes) vadcodclip2.gif (34378 bytes)

Here is a shot of the inside of the piece, see the belt actually runs across the piece, the clip is on the right-hand side. you slip your left leg into the harness, then lift it to your waist and secure the belt at your right hand side, this is an incredibly stable harness - Below Pictures...

vadcod.gif (29542 bytes)

 

NEW COD DESIGN - $20 complete stars2.gif (222 bytes)

This new design cod-piece just goes to show that when you make a prop, accessory, whatever - you always get better each time you make one!, look at this, based on the ROTJ Cod Piece, it was made in nearly half the time of the original version above!! - Below Pictures...

cod2-1.gif (28282 bytes) cod2-2.gif (25473 bytes)

Send us pics of your own cod pieces and we'll show them here!

IF YOU WOULD RATHER PURCHASE THAN MAKE THIS ITEM
VaderMaker Recommends!
For your Cod Piece...

recommendssbanner.gif (5364 bytes)

home

- It is our time to march forth and rid the galaxy of the filth of the Rebellion -

This site is in no way sponsored or endorsed by: George Lucas, Lucasfilm Ltd., LucasArts Entertainment Co., or any affiliates. All copyrights ©, registered trademarks ®, trademarks (TM), or service mark (SM) used belong to their respective owners.
VaderMaker and TroopersRus2 are copyright Graham Campbell, 2000.